Concentric & threaded hole
Free preview lesson from the course Autodesk Inventor essentials course.
What this lesson covers
Now I'm going to show you just one more because if I click whole and I click this surface and Then I haven't placed it yet, but I click this outer edge It's gonna understand. They're gonna be concentric Now I'm cutting a hole in an empty space. I'm gonna go Let's just make it 0.5 so that is bigger so that it does cut But I'm only gonna go Let's just go down Yeah let's go Want to do a flat bottom and notice this as well flat and So I'm only gonna go about halfway through I'm on a click. Okay, and So there I've got a hole that kind of cuts into this as a Certain distance, but it's very convenient if you're gonna put a hole down something cylindrical So you might have, you know, consider that when you did your sketch Not even bother with the center point of it. Just use the whole command after it's just two ways to the same place In this case, I needed a bigger hole after the fact so And again, you can come back you can edit these and I kind of want to point out just a couple little things that you can also do with a hole and The main thing is you can put threads on it Threads and it's ANSI quarter inch or quarter UNC I'm not gonna do much, but you've got a bunch of different isometric isopipe threads and So one so you can get threads on these not gonna do anything crazy here I'm just gonna click okay, and you might notice now it gets say it looks like threads It's pictorial, but it is very representative of this is what it's it's threads through a hole and so it's very Very nice that you can do that in the same command and So once you've got your holes Your satellites and stuff It is just a matter of continuing to make make different things Say I wanted a handle on this Start a new sketch Place maybe it's a cylinder in this case Just gonna make one dimension it There point one two five I'm just gonna go a certain distance from that circle to this center point point five and It's looking for so few if you're ever wondering what what are you looking for it says one dimension is needed down in the right corner down here in the corner and So try to kind of click it drag it see what happens see which way you can go with it Well, it's the the horizontal or vertical So that or you draw a construction line or a helpline or whatever you want to do Gets it fully constrained. I use e for extrude now I'm gonna go Just a quarter of an inch say this is a handle However, you want to go It's just a matter of keeping adding Sketches adding features cutting away adding Subtracting however you want to call it To get to the part you want, but I want to emphasize something I said in the beginning to make your first sketch as simple as possible and Build on it make multiple extrusions and whatever not and also it's a nice I'm just gonna do so if I do a sketch and I didn't need that one I'm gonna hit finish and and you go. I'm gonna do one here. I need that one. So I'm gonna do something there Just I'm gonna go very Brutally here. I'm gonna go extrude. Yeah, that's fine