Hinges
Free preview lesson from the course Design for manufacturing for injection molding.
What this lesson covers
We're now going to have a look at a couple of case studies for DFM for injection molding and see how you can put some of these tips into practice. For the first one, let's consider a simple hinged enclosure like this. At first glance it seems quite good for molding, we've got two halves that are quite similar, we've got a nice draft angle on the walls, we've got rounded edges and if we look inside we've got a good uniform wall thickness here. But the hinged section on the right could cause us some difficulties. The idea here is that a metal pin would go through these barrels of the hinge and it would act as an axle allowing them to open, but from a molding DFM point of view this isn't ideal. If we look at the parts they'll probably be molded from the top, so this hole for the pin is actually an undercut and it would need some kind of side action in the mold which would make it more complex and more expensive and it's the same for the other half too. Also if we think about the actual procedure in the assembly here, having a metal pin here has some other downsides. Firstly we need to actually source and buy the pin so it's another cost for the product and it's another layer of complexity with more suppliers and things like that. The pin also has to be fitted correctly so how does it fit in there? Is it a push fit? If so, do we need a special machine to fit it and how do we calculate the correct fit? If it's too loose then it will just fall out but if it's too tight then it might split the plastic. If it's not a push fit and it's maybe glued in for example then we need to get the glue, we need to train the assembly workers on the correct process and so on. For example we need to make sure that we don't accidentally glue the two halves together when we're gluing the pin in. So it might be better if we could completely remove that metal pin from the equation and have a think now about how we could do this. You might have seen some solutions in everyday objects around you. We could do something like this, this is taken from a real molded product that I designed and we remove the pin completely. On the main body down here we have the circular axle or rod that's attached to the body and the way it's modelled means that this can be molded quite easily. There aren't any undercuts there or problems with the draft angle and then on the lid on the top we now have these alternating clips that attach to the axle and because these alternate they don't have any undercut areas either and this could also be molded pretty easily. But probably the best thing here is now that the parts don't need any complex assembly with glue or machines, they just snap together. It could even be that the parts are shipped unassembled, it might allow for more efficient shipping and then the customer just assembles them by clipping the lid on. One of my design teachers when I was at university always used to talk about this kiss principle, keep it simple stupid. So try to reduce the complexity of your parts and assemblies when you can but understand that this doesn't necessarily mean that you have to compromise on the function.